haas TM-2 2005 G83 feed issue


Results 1 to 3 of 3

Thread: haas TM-2 2005 G83 feed issue

  1. #1
    Registered
    Join Date
    Mar 2008
    Location
    USA
    Posts
    9
    Downloads
    0
    Uploads
    0

    Default haas TM-2 2005 G83 feed issue

    Hey guys.
    I have a 2005 Tm-2, and have an issue I was hoping one of you may have some insight on. All of the sudden when I perform a 83 peck drill all of the retracting motion is in feed instead of rapid. I recently used a program from someone else's cam software . Not sure if the coding used may have set up some type of modal issue that I am unaware of . I pretty much have been scratching my head on this one and hoping for some help.
    Thanx in advance.

    Dave

    Similar Threads:


  2. #2
    Registered
    Join Date
    Nov 2006
    Location
    US
    Posts
    482
    Downloads
    0
    Uploads
    0

    Default Re: haas TM-2 2005 G83 feed issue

    I can't speak to that specific problem, but I will say that I've indeed seen some CAM programs that output their own special type of peck cycle which consists of G0 and G1 movements moving up and down, rather than G83 / G73. I'd definitely check the code to see if there's like 20 lines for that one hole, rather than a single drill cycle



  3. #3
    Gold Member Machineit's Avatar
    Join Date
    Mar 2010
    Location
    USA
    Posts
    1769
    Downloads
    0
    Uploads
    0

    Default Re: haas TM-2 2005 G83 feed issue

    If it actually says "G83," it is not in some strange code, that is a regular G83 cycle. Please post the code for us to see.

    Two Haas VF-2's, Haas HA5C, Haas HRT-9, Hardinge CHNC 1, Bother HS-300 Wire EDM, BobCAD V23, BobCAD V28


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

haas TM-2 2005 G83 feed issue

haas TM-2 2005 G83 feed issue