Is there a M-code controllable 110v outlet on the Haas?

[kentdesautel13]

I am wondering if there is a 110/120 power outlet or source inside the cabinet on the haas that can be controlled with M-code or control panel settings?

I do have an outlet on my electrical cabinet

I have rigged up a small transfer pump that I use to help get coolant from inside the machine back down into the coolant tank. I was constantly fighting plugged drains on my mini mill, so I just added this transfer pump and it solved the problem.

But I don't want it to run constant.... I want to have it turn on and off similar to my chip auger which is currently controlled by settings ( I can't remember, but I believe its a setting on the control panel )

The mini mill has a tank that is part of the frame, so getting that drain pan clean of chips is a nasty time consuming job..... so that's why I went the route of the transfer pump.

Thanks,

Kent

Similar Threads:

• VFD 110V-110V parameters setting
• Variable frequency 110V line 110v motor????
• Advice On Using 220V Machine With 110V Wall Outlet
• Need Help!- s1 MOTOR NOT CONTROLLABLE! HELP ME !
• fanuc program code vs. Haas code

[djr76]

Find a 110 power source in the cabinet, run the red to one side of pump, the other wire from pump to n.o on spare m code relay, run white side of power source to common. I have air solenoids that are tied to the m51 relay in my machines, M51 on, M61 off.

[rodw]

Haas has some gcode triggerable relays built in but they may be an optional accessory so may not be fitted on your machine. Check their web site and your documents.