Haas 5C rotary with control box---Air-Hot Alarm

Results 1 to 2 of 2

Thread: Haas 5C rotary with control box---Air-Hot Alarm

  1. #1
    kev16here's Avatar
    Join Date
    Jun 2021
    Posts
    0
    Downloads
    0
    Uploads
    0

    Default Haas 5C rotary with control box---Air-Hot Alarm

    Hi there!


    Haas 5C with control box. Single cable, brush type, 17 pin. Worked good. Used it last year, no problem. It was sitting for a while, got a battery alarm. Opened controller, measured old blue battery, only had 0.3V.
    Replaced battery with new one (could not find the same blue, used a yellow one made in japan, the same as other Haas machines have). Now it is 3.10V.
    Since battery replacement, cannot make it work anymore. Push "START" button and the "AIR HOT" message is displayed. Cannot send rotary to home position, looks like there is no communication between rotary and the controller.

    Cable is good, measured all 17 pins from end to end, checked connectors inside the box.

    Are parameters get reset after battery replacement?

    Any suggestion how to check the rotary? Encoder?

    Can the rotary go bad just sitting? What is wearing out inside while doing nothing?

    Searched net, found no cure so far.

    Would appreciate any input, experience with rotary control box and connection problems.

    Let me know what you have!

    Thank you!

    Kev

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Haas 5C rotary with control box---Air-Hot Alarm-img_20210228_173947915-jpg   Haas 5C rotary with control box---Air-Hot Alarm-img_20210105_155708245-jpg   Haas 5C rotary with control box---Air-Hot Alarm-img_20210105_155805593-jpg  


  2. #2
    Member machinehop5's Avatar
    Join Date
    Aug 2009
    Location
    United States
    Posts
    1048
    Downloads
    4
    Uploads
    2

    Default Re: Haas 5C rotary with control box---Air-Hot Alarm

    ...try resetting the controller "Initialize Servo Control to Factory Default Parameters"
    Chapter 2.3 (page 8)
    https://www.haascnc.com/content/dam/...ual---2017.pdf
    goodluck



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Haas 5C rotary with control box---Air-Hot Alarm

Haas 5C rotary with control box---Air-Hot Alarm

Haas 5C rotary with control box---Air-Hot Alarm