- Haas lathe, G71 P and Q parameters
-
Member
Haas lathe, G71 P and Q parameters
Hello machinists!
I have a question regarding P and Q section you specify when calling G71 (O.D./I.D. Stock Removal Cycle).
What exactly can be in the section bounded by P and Q values? The manual only says that you can call subprograms..
But what about GOTOs, WHILEs, work offsets (e.g. G54), etc.?
In advance thanks.
Similar Threads:
-
- Haas lathe, G71 P and Q parameters
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules