Need Help! St-15 v axis alarm


Results 1 to 2 of 2

Thread: St-15 v axis alarm

  1. #1
    Member
    Join Date
    Jul 2006
    Location
    usa
    Posts
    297
    Downloads
    0
    Uploads
    0

    Default St-15 v axis alarm

    2017 ST-15 went to install a 2016 servo 300 barfeeder today,after installing the cables,and changing parameters i get a v axis alarm 832, i cannot clear the alarm or get into the parameters to change them back to factory.

    any suggestions would help

    thank yu in advance.

    Similar Threads:
    2007 Haas TMP-1 Microscribe MX-5 Mastercam X4 Mill Level 3 Surfaces,Solids Seagate 2 tb hard drive AMD 64x2 8gig ram windows ultimate 7 64bit Geoforce 8800 GTX


  2. #2
    Member
    Join Date
    Jul 2006
    Location
    usa
    Posts
    297
    Downloads
    0
    Uploads
    0

    Default Re: St-15 v axis alarm

    i got it, i did not realize there was amphenol connector underneath and inside the sheetmetal

    connected it and it allowed me to access parameter list

    i am getting a 835 v axis serial data communication alarm i cant figure out but im sure Haas will have an answer for that tomorrow when they open.

    2007 Haas TMP-1 Microscribe MX-5 Mastercam X4 Mill Level 3 Surfaces,Solids Seagate 2 tb hard drive AMD 64x2 8gig ram windows ultimate 7 64bit Geoforce 8800 GTX


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

St-15 v axis alarm

St-15 v axis alarm

St-15 v axis alarm