St-15 v axis alarm

[timmydabull]

2017 ST-15 went to install a 2016 servo 300 barfeeder today,after installing the cables,and changing parameters i get a v axis alarm 832, i cannot clear the alarm or get into the parameters to change them back to factory.

any suggestions would help

thank yu in advance.

Similar Threads:

• Need Help!- Arrow2 750 - Axis Puls enable alarm & X-Axis drive alarm
• Need Help!- Fanuc 10tf, Axis Torque Alarm, mem Z axis Alarm, already changed Z drive and motor?
• Need Help!- 414 SERVO ALARM: V AXIS DETECTED ERR , and 449 V AXIS: INV.IPM ALARM
• Need Help!- Alarm 414 Servo Alarm : Y axis detect error
• Problem- 300 APC Alarm : Y Axis need zrn & 306 APC Alarm: Y axis battery zero on Fanuc 16i-LA

[timmydabull]

i got it, i did not realize there was amphenol connector underneath and inside the sheetmetal

connected it and it allowed me to access parameter list

i am getting a 835 v axis serial data communication alarm i cant figure out but im sure Haas will have an answer for that tomorrow when they open.