Need Help! 304 invalid I,J, OR K in G02 or G03


Results 1 to 5 of 5

Thread: 304 invalid I,J, OR K in G02 or G03

  1. #1
    Member Awbrey-p's Avatar
    Join Date
    Jan 2021
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default 304 invalid I,J, OR K in G02 or G03

    I'm currently training in CNC Lathe but I'm running into an issue with the arch. I am currently on a Haas Simulator. My instructions were to use IJK but I'm struggling.


    Thanks
    Awbrey P

    Similar Threads:
    Attached Thumbnails Attached Thumbnails 304 invalid I,J, OR K in G02 or G03-1611764216139680663278259133650-jpg  
    Last edited by Awbrey-p; 01-27-2021 at 11:39 AM.


  2. #2
    Member machinehop5's Avatar
    Join Date
    Aug 2009
    Location
    United States
    Posts
    1567
    Downloads
    5
    Uploads
    2

    Default Re: 304 invalid I,J, OR K in G02 or G03

    ...try using R for arc center. Read more about it below link
    https://www.haascnc.com/service/code...value=G03.html

    sip-
    The R-value defines the distance from the starting point to the center of the circle. Use a positive R-value for radii of 180 or less, and a negative R-value for radii more than 180.



  3. #3
    Member
    Join Date
    Feb 2011
    Location
    usa
    Posts
    353
    Downloads
    2
    Uploads
    0

    Default Re: 304 invalid I,J, OR K in G02 or G03

    with out the information on the print it will be hard to give you the correct answer
    if the arc is being cut from .440 in the x axis to a smaller x value then back to the .440 dia.(G2)
    with the z axis starting at -.565 and finishing at -.940 your k value would be k-.1875



  4. #4
    Member machinehop5's Avatar
    Join Date
    Aug 2009
    Location
    United States
    Posts
    1567
    Downloads
    5
    Uploads
    2

    Default Re: 304 invalid I,J, OR K in G02 or G03

    ...sim report when fixed. Followup

    over vs under Newton's Law



  5. #5
    Member Awbrey-p's Avatar
    Join Date
    Jan 2021
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Re: 304 invalid I,J, OR K in G02 or G03

    Thank you all for the suggestions but we just
    Split the arch into two partials and it worked



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

304 invalid I,J, OR K in G02 or G03

304 invalid I,J, OR K in G02 or G03