VPS bug for facing?


Results 1 to 1 of 1

Thread: VPS bug for facing?

  1. #1
    Member
    Join Date
    May 2016
    Location
    United States
    Posts
    6
    Downloads
    0
    Uploads
    0

    Default VPS bug for facing?

    hi, i've got a TL-1 lathe and i think i've found a bug in the VPS face operation. i'm wondering if anyone can confirm this, or if i'm doing something stupid.

    here's what's happening: the FACE_STOCK setting is described as "Enter the total amount of STOCK to remove from the FACE of the part" and i'm entering 0.04 and when i run it, it will start the operation 0.04" in front of the actual face of the part.

    it then does face passes in the air, and then ends the operation before it actually reaches the real face of the part. and yes, i've triple checked the Z-face offset of the part. i've rebooted, and tried again, and it just seems to be confused about what it's doing.

    i thought to put negative 0.04" in the FACE_STOCK variable, but it won't let me.

    again, am i doing something stupid or is this a bug?


    VPS bug for facing?-img_5775-jpg

    Similar Threads:
    Attached Thumbnails Attached Thumbnails VPS bug for facing?-img_5775-jpg   VPS bug for facing?-img_5775-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

VPS bug for facing?

VPS bug for facing?

VPS bug for facing?