HAAS HL SERIES LATHE

[CNCSETTER01]

I am trying to realign turret on HAAS HL-2 I have followed steps in manual but cannot find how to jog the a axis.I have changed the invisible axis to enable the A axis as advised but cannot find a button to jog the A axis.In the manual it says it is below the z+ button but I cannot feel a button there.I would be grateful for any feedback, thanks in anticipation

Similar Threads:

• Need Help!- Using Haas 300 bar feeder w/ Haas TL1 tool room lathe
• someone used mastercam for haas tl series
• Tool post grinder for haas TL series lathe
• HAAS VF-3 1995 series
• Haas GR series routers for granite?

[djr76]

Hit "A", then handle jog button, then use jog wheel.