STAR 4 POSITION TURRET ON TL-1?


Results 1 to 3 of 3

Thread: STAR 4 POSITION TURRET ON TL-1?

  1. #1
    Registered
    Join Date
    Mar 2008
    Location
    USA
    Posts
    108
    Downloads
    0
    Uploads
    0

    Default STAR 4 POSITION TURRET ON TL-1?

    I'm looking to purchase a Haas TL-2 tool room lathe. The one I'm looking at has just the gang plate with an Aloris style post. Can I install a Star 4 position tool turret on this lathe if it wasn't on there from the factory? Would it be wired and ready to accept a powered turret?

    Similar Threads:


  2. #2
    Member LeWhite's Avatar
    Join Date
    Dec 2011
    Location
    usa
    Posts
    295
    Downloads
    0
    Uploads
    0

    Default Re: STAR 4 POSITION TURRET ON TL-1?

    Since no one has answered. I tried to interface a turret to a TL1. Did it work: Yes. Was it a success, well kinda.. I guess I could have thrown more money and time at the machine and seen it to perfection or I could have left the gang slide on it and maybe pallerised a few tool racks, which in hindsight would have been a better choice. I just bailed and got a ST



  3. #3
    Registered
    Join Date
    Mar 2008
    Location
    USA
    Posts
    108
    Downloads
    0
    Uploads
    0

    Default Re: STAR 4 POSITION TURRET ON TL-1?

    Thanks for the reply...I have chosen a different machine as well. It was either spend less for a different brand machine that has the 4 position turret or move up to the SL, I chose a different brand for less.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

STAR 4 POSITION TURRET ON TL-1?

STAR 4 POSITION TURRET ON TL-1?

STAR 4 POSITION TURRET ON TL-1?