Gibbscam 4 axis toolpath

[Anonymous007]

I have been programming with Gibbscam for 10+ years, but everything has been 3 axis, or 3+2 machining. I just got a part that has radial, blind slots. I have been messing around for numerous hours trying to figure out how to program this with smooth 4 axis contours, and cannot figure it out.
Part is going to be machined in a Matsuura MX-330 with the radial machining about the Y-axis.
Being programmed with Gibbscam Version 12 with all 4 and 5 axis modules.

Any help in regards to how to properly apply toolpaths to radially contour the slot and radially pocket the bottom, it would be GREATLY appreciated.

Parasolid Attached

Thanks

Similar Threads:

• 4 axis toolpath
• NX7 3+2 axis toolpath
• Toolpath in 4th axis
• 4 -axis toolpath?
• 4th Axis Toolpath with mastercam

[MACHINEFREAK]

PM me