- Gerber Sabre 408
-
Registered
Gerber Sabre 408
Hi Guys hoping someone can help,
Gerber Sabre 408 router on startup gives the error Z axis encoder/motor.
The amp light is on in the main board , in the control box all 3 servo drives have a red led.
I switched over the cables from the Y axis motor and encoder to the Z axis and same alarm.
I switched the servo drives over and same alarm, i checked all limit switches as per the "faultfinding".
Would anyone have an electrical schematic for this machine , or any ideas on the fault
Best regards
Bulld
Similar Threads:
-
- Gerber Sabre 408
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules