lighted acrylic signs

Results 1 to 5 of 5

Thread: lighted acrylic signs

  1. #1

    Default lighted acrylic signs

    has anyone attempted these with cut2d and an end mill bit?

    Similar Threads:


  2. #2
    Member
    Join Date
    May 2006
    Location
    USA
    Posts
    803
    Downloads
    0
    Uploads
    0

    Default Re: lighted acrylic signs

    Shouldn't be a problem to do that
    Show us the drawing..........

    Attached Thumbnails Attached Thumbnails lighted acrylic signs-amp-window-3-jpg  
    Been doing this too long


  3. #3

    Default Re: lighted acrylic signs

    don't have a drawing, was just curious since i don't have vcarve. what would be a good cut depth?



  4. #4
    Member
    Join Date
    May 2006
    Location
    USA
    Posts
    803
    Downloads
    0
    Uploads
    0

    Default Re: lighted acrylic signs

    to begin, never more depth than diameter .004 feed per tooth. rpm according to surface feet per minute.

    Been doing this too long


  5. #5
    Registered
    Join Date
    Jan 2013
    Location
    usa
    Posts
    22
    Downloads
    0
    Uploads
    0

    Default Re: lighted acrylic signs

    I use a diamond drag for anything that will be seen from at least a few feet away. .02 step over cross hatch pattern it works quite well for the signs I make
    lighted acrylic signs-img_20170113_094558571-jpg



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

lighted acrylic signs

lighted acrylic signs