DIY Stencil Cutting Drag Knife Solution - Update 4!

[Dread]

There is on Bbay a drag knife holder and carbide blades (30,45,60 degree)for sell, typically for for Graphtec, and Roland Vinyl cutters. Look up CB09 holders and go from there.

Hope this will help someone.

[ozyjimbo]

it should work with aspire make your tool path for engraving with a diamond drag bit this will allow you to set pressure of course i haven't done this so you will have to trial and error and just save the post processor as you normally do for mach3 and turn off spindle