Hi everybody, first post here so if I'm in the wrong area for this please redirect me to the most appropriate forum. Hate being a newb but we gotta start somewhere, cheers

I am in the process of starting up a new to me 1994 Eagle 3 axis mill with an Anilam 1100 3axis control.
Started up fine and when I get to the screen where the dro shows up the x axis will not count on the DRO. The servos will power up and go back to manual like they should the Y axis reads but not the x axis. I switched cables from x to y and the problem moved to the y axis so I suppose the encoders are good on both as well. Any bets on bad board, bad cable, ???
Thanks, Doug
Just the first of many ??? and I'll do my best to ask better questions as I learn.

Similar Threads: