- Kitamura mycenter 0 axis over-travel
-
Member
Kitamura mycenter 0 axis over-travel
I managed to jog my Z too far (Towards the table) and now I am stuck with a E-stop alarm. Is there an easier way to jog it back off the limit other than removing the switch? The control is a yasnac i80m. I think its a 1996.
Similar Threads:
-
-
Member
Re: Kitamura mycenter 0 axis over-travel
Since its been a while, you must have found the override temporary switch on the front of the control? Good luck!
- Kitamura mycenter 0 axis over-travel
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules