Torchmate 3 Cut-Height issue

[STGrilles]

Hello,

I have a torchmate 3 cnc plasma table with a hypertherm pwmx 105 on it. Its all plumbed and plasma fires good and everything. It was working good, but now the torch goes down and touches metal and wont spark, it wont come up to the 0.02 cut height or whatever it may be. I am cutting 18 gauge cold rolled mild steel. Please help as I need to get this thing cutting asap ! All settings in the avhc are on manual set by the book

Thanks

Similar Threads:

• Help Connecting Miller Spectrum 2050 to Torchmate w/height control
• Torchmate Voltage Height Control an Steppers
• torchmate 2 height controller issues
• Torchmate, Torch height controllers?
• Torchmate, Torch height controller, problem?

[coherent]

It could be a number of things. Sounds like maybe the ATHC to me. If I were you I'd call Torchmate tech support. They are fairly receptive and helpful. There's also lots of troubleshooting info on their web pages.