- Dynapath Delta 10 on J head upgrade
-
Registered
Dynapath Delta 10 on J head upgrade
Hello all, I recently purchased a very clean step pulley 9x42 bridgeport with dynapath delta 10, the delta control has a bad power supply, it could be repaired but my thought is to re use the servo motors upgrade encoders and software and drivers. the motors are coupled 1:1 on x and y and a reduction on Z, i have spoken with a few people and they have said to go gecko drives and steppers, then again i read elsewhere that servos are better what gives? looking for opinions to be more educated and take an average of what is said.
thanks
Jon
Similar Threads:
-
- Dynapath Delta 10 on J head upgrade
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules