The 6332M-B (EC) controller in my Co2 laser seems to be defective, I've lost control of the X axis. Not the stepper motor (replaced it) or the X driver (as far as I can tell), the X axis tries to move but acts like it has "brakes" on and it's locked up. The problem started in the middle of a program I've run 20 times before cutting a sheet of acrylic. It was running fine for half the sheet and then the X axis stopped working.
I'm having trouble sourcing the 6332M-B (EC) in time to finish a job but I can get the 6332G in time. The boards look physically the same, can I just swap the 6332G for the defective 6332M-B?

Anyone know?

Tim

Similar Threads: