Hi folks
I have converted a ten high 6040 with s as new Ruida controller
I have a couple of issues
The machine has nema 17 motors
I have ( purchased leadshine drivers 562 I think that came with a pair of nema 23
Motors
I don’t want to put the motors in as it is a lot of faff making new mounts ect
The drivers I just can’t get running the motors ( nema 17 ) well
The x is perfect but if I use same dip settings for y it’s awful I just don’t know where to start
Anyone got a Ruida machine with drivers and nema 17 motors? If so can you give me your dip settings
I also have a issue with laser
It cuts fine but engrave is missing laser fire pulse I didn’t know if the oversized drivers are pulling to much power during an engrave
Any help appreciated
Stepper driver settings do two things. Sets the revolutions per step and how much power is used to drive the motor.
I would ask it to cut a simple square then play with the units setting until it’s correct. You can also get it close and tune with software settings
Power is a trade off between loosing steps at high accelerations and heating up the motor. Just lower power if it gets hot in long cuts.