TRUMATIC L3030 - 3000W - problem with PLC - inquiry


Results 1 to 1 of 1

Thread: TRUMATIC L3030 - 3000W - problem with PLC - inquiry

  1. #1
    Member bencaha's Avatar
    Join Date
    Jul 2020
    Posts
    3
    Downloads
    0
    Uploads
    0

    Question TRUMATIC L3030 - 3000W - problem with PLC - inquiry

    Hi,


    we have a trumpf machine L3030 - 3000W. I reset the Siemens 840D according to the manuals and instructions. He played from the NCK machine and then the PLC.

    I refurbished one faulty servo. Restored the system from backup - functional.

    The laser writes the following two errors after approaching:

    1.)

    F29.03.21 12:56:30 PLC (80.102000): The machine dautm 15101 is not defined

    2.)
    29.03.21 12:52:05 PLC (07.000000): Feed pot is situated at 0


    When connected to the 840D, I see everything OK, both the memory and all the modules and the system time fit.

    It does not make any sense.

    Does anyone have this laser PLC and NCK data? I have several versions and the error is the same.

    Isn't it possible that some memory has gone?


    Thank you.

    Attached Thumbnails Attached Thumbnails TRUMATIC L3030 - 3000W - problem with PLC - inquiry-trumpf1-jpg   TRUMATIC L3030 - 3000W - problem with PLC - inquiry-trumpf2-jpg  


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

TRUMATIC L3030 - 3000W - problem with PLC - inquiry

TRUMATIC L3030 - 3000W - problem with PLC - inquiry