i bought the same machine, I also could not get it to work. I ended up removing the control board and replacing it with a cohesion 3D board and lightburn software. It works very nicely now
Could you give me an advice please?
I bought a laser with motherboard m2 nano (80w 1060 chinese). I installed coreldraw and corellaser, listed id motherboard, connect usb cable and usb dongle,but it still reports to me Laser machine is disconnected.
Please advise what I'm doing wrong?
Photos from installation attached.
Thank you very much.
Similar Threads:
i bought the same machine, I also could not get it to work. I ended up removing the control board and replacing it with a cohesion 3D board and lightburn software. It works very nicely now