Run at 65% power.
Sent from my SM-G935F using Tapatalk
Hi, I've got a K40 laser that is set up with air assist. I'm struggling to cut 3mm MDF with a single or even a double pass even though I've got the machine on full power on 5mm.
Not entirely sure what the issue is, I've tried Googling and looking for answers but can't really find anything. I've read that these machines can cut 6mm MDF with 2 passes therefore would have assumed cutting 3mm MDF should be no problem at all, especially running at full power.
Any ideas?
Similar Threads:
Run at 65% power.
Sent from my SM-G935F using Tapatalk
TokinSpokane
Custom Crafts