Hello,What's your version of EZCAD software?We have a software and can send it to you.
I purchased a fiber laser engraving machine from china a few months ago. EZCAD 2 kept crashing on the Windows 7 computer they sent me. Finally im guessing some of the components in the computer they sent with the machine were less than adequate and the computer took a turn. I have since purchased a laptop for use on the machine only. I was hoping someone could point me in the right direction getting software to work on windows 10 OS so that i have a reliable computer to work off of. Very new to fiber laser but the possibilities are endless and am willing to handle the learning curve. I just need a little help here and there. Thanks in advance!
Similar Threads:
- Need Help!- Morn Fiber laser/ezcad2 stuck in demo mode
Hello,What's your version of EZCAD software?We have a software and can send it to you.
The EZCAD version 2.14.9 is compatible with Win10 64 bits.Do you have the installation file?I have but I don't know how to upload the file this page.
Here is the software.
Here is a video to install EZCAD2 to computer with Windows 10 OS.
i need the drive of ezcad for window 10 - 64 bit please
OK.Here is a file which include drive and software EZCAD 2.14.10.And here is a video to show how to uninstall the drive.
Sorry the file is too large and I was thinking it was uploaded.You can send a personal message to me.
Last edited by Opticlaser; 09-10-2019 at 09:53 PM.
Here is a link for the drive and software.
https://drive.google.com/file/d/1rPP...ew?usp=sharing
hi,I tried to acces your link but is missing I can't find it can you please send me the link because I have win 10 and it's not working and it gets so frustrating when whenever I try it showes "no dongle" so If you could help me it will be great.Thank you
Link works perfectly.
Make no mistake between my personality and my attitude.
My personality is who I am. My attitude depends on who you are.
I test the link and I can download it without problem.If you need the driver or software,I can send you privately too.
i've installed ubs driver but still shows info about missing dong
Can you download the driver and software?
hello
yes, i can and i did it.
i updated driver as shown on YT movie but already have te same driver.
Unfortunately software still says about missing dong
I have Ezcad2.9.9 and It was working fine with windows 7. and Install Windows 10 64bit version and when software opening it's saying "Can not find dongle.demo state".
when i try to engrave it's saying "Current LMC Board is not for fiber Laser"
And parameter setting F3 hardware info showing "invalid board"
but i tried to work with windows 7 again (old hard drive) it was working file.I think problem with windows 10 64bit. installation issue.
Does anyone have Ezcad2.9.9 software and drivers for windows 10 64bit?
or any other solution for it?
Thank you
from Sri Lanka
link good, tks
may loc nuoc RO | Nap bon cau thong minh | http://comath.com.vn | http://xomcho.net