In need of feedback Co2 laser


Results 1 to 2 of 2

Thread: In need of feedback Co2 laser

  1. #1
    markJL's Avatar
    Join Date
    Jul 2018
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default In need of feedback Co2 laser

    Recently sent out Laser for re-gas after drop off of power to about 30% of full speed.

    Returned I installed, start to cut single cuts just to test? on .125" clear acrylic
    result: work fine all 4 areas of a 12 x 24 production sheet.

    Proceeded to set up nested production file and started fine.
    Result: Starting from the right top laser works fine about 1/2 way it looses cutting depth.

    Check beam alignment and made small small change proceeded to single cut all four sides
    Result: Works well.

    Check all wired and fitings
    Result: everything tight and clean

    Clean optics
    Result:Ok but still order new Focus lens not installed at this time.

    Isolated power input places on single circuit with industrial cord. Then ran production parts again.
    Result the same good 1/2 way rest not cut thru.

    Table true and flat

    Question, The machine is acting like the laser is dropping when active for some time cannot see anything else and wish to here some ideas if possible.

    Thank you
    M



  2. #2
    Registered
    Join Date
    Nov 2010
    Location
    Poland
    Posts
    717
    Downloads
    0
    Uploads
    0

    Default Re: In need of feedback Co2 laser

    Start cutting from far end and you will know is it loosing power or has low power at all.

    CNC lasers, constructions, service


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

In need of feedback Co2 laser

In need of feedback Co2 laser