As long as laser works it is not broken.
Did you check all groud cables in your machine?
Chinese have only 2 wire wall instalation so thay are not used to make proper grounding.
Call for electrician to check it.
Is it normal,? I have chinese machine 80 watt laser (RECI genuine) I used a bucket and water pump as cooler for the laser tube, the water inside the bucket are electrified.
Is it normal for the water to get electrified from the laser tube?
Or my laser tube is damaging / broken and that's why it passes electricity into the water.
Sent from my Redmi 4A using Tapatalk
Similar Threads:
As long as laser works it is not broken.
Did you check all groud cables in your machine?
Chinese have only 2 wire wall instalation so thay are not used to make proper grounding.
Call for electrician to check it.
CNC lasers, constructions, service
Don’t touch the water and you will be good Togo.
Sent from my iPhone using Tapatalk
I would say, your water pump is faulty, and should be replace before someone gets electrocuted, the Chinese supplied water pumps should not be used as they have no Ground, or are not double insulated, check the Machine Grounds as well, they may not be up to code as well, this is a must check for all Chinese Machines, as in China they are not required to use a Ground, which results in lots of deaths from electrocution
Mactec54