Need Help! Searching AWC708C Lite Simple English manual


Results 1 to 3 of 3

Thread: Searching AWC708C Lite Simple English manual

  1. #1
    Registered ifeliciano's Avatar
    Join Date
    Mar 2005
    Location
    United States
    Posts
    109
    Downloads
    0
    Uploads
    0

    Default Searching AWC708C Lite Simple English manual

    Has anyone that uses the Trocen AWC708C Lite found an easy to understand English manual? I'm referring to a manual simple to understand that explains all the settings in simple terms. Not a Chinese English translated manual.
    I have manuals from Trocen and Sinjoe, but both are Chinese English, which is difficult to understand.

    A few problems i'd like to correct.

    1. Y motor stalling
    2. Slow down homing at power up speeds
    3. Change homing sensor state to normally closed (NC)
    4. Set home or origin (0,0) to front left of the X-Y Stage.

    Similar Threads:


  2. #2
    Member
    Join Date
    Nov 2008
    Location
    USA
    Posts
    644
    Downloads
    0
    Uploads
    0

    Default Re: Searching AWC708C Lite Simple English manual

    Y motor stalling like it won’t run at all? Not wired correctly?
    Or looses steps when trying to rapidly move the X axis? Bigger motor or settings on the drive.

    In the software You could have accelerations too high or step settings too large for the pulse settings on the drive.
    It might be best to work everything out with the belts disconnected first

    Rest of that stuff can be found if you study the settings carefully.


    Sent from my iPhone using Tapatalk



  3. #3
    Registered ifeliciano's Avatar
    Join Date
    Mar 2005
    Location
    United States
    Posts
    109
    Downloads
    0
    Uploads
    0

    Default Re: Searching AWC708C Lite Simple English manual

    Thanks Dean. Y motor issues were a current setting on the driver. I dropped them to 2.7A from 3A and are working fine now.
    I got the Light Object manual for the LO-X7 DSP which is a AWC708C and made some headway. Reading from all three manuals helped, but not much. Also found loads of info at the Buildlog 2.X DIY Laser forum.
    I was not able to find any info on the homing switch state. It seems I can only enable/disable the setting, and switches need to be wired as NO.
    Home at (0,0) was weird. I had to set Datum in Manufacturer Parameters. Now to figure out how to do motor tuning.

    Last edited by ifeliciano; 12-27-2017 at 11:03 AM.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Searching AWC708C Lite Simple English manual

Searching AWC708C Lite Simple English manual