BLUM LASER NT WITH HEIDENHAIN CONTROL MEASUREMENT ISSUE

[solowalker41]

Hi i am using Blum Laser NT for measuring ball nose of 12 mm of Dia using 584 TCH PROBLE Cycle.
I am predefining all of the parameters in the TOOL list according to the attached Picture.
But after measurements it updated the tool lengh and Diameter with the differnce of 3mm in Length(i have measured the tool length on tool presetter) and .6mm in Diameter.
I am unable to resolve this issue . If anyone knows about this, help me plz. I will be thankful.

Similar Threads:

• Europe BLUM LASER TECHNOLOGY
• Issue with Heidenhain TNC 135 control
• Hermle C 30 U BLUM laser help
• BLUM laser help
• Blum laser macros