- HEIDENHAIN iTNC530
-
Registered
HEIDENHAIN iTNC530
Dear every one
I have machining center with HEIDENHAIN iTNC530 control ,when i turn on machine ,i have {exchange buffer battery} .
I want to know if i exchange it ,parameters and program of machine will be clear ? or no ?
best regard
ali
Similar Threads:
-
-
Member
you need to exchange it as soon as possible as this is back up power for memory when machine is powered off
mick
-
Member
Hi,
Well, all the information except the date and the clock is on the harddisk.
So you won't loose parameters nor programs.
Anyway, I too advice you to change the battery. It is Renata CR2450N.
Make sure you will get the right battery. (not just normal 2450)
Jukka
-
Registered
Make sure you have the machine powered up when you change the batteries. I bought a used machine and by the time I got a big enough phase converter(5-6 mos) it lost all machine parameters and programs and previous owner didn't make a back up copy of parameters. Someone should make battery tender like for motorcycles to keep plugged into 110 to keep batterys charged. Mine with heidenhain uses 3 AA batteries.
Good luck, JD
-
Registered
Re: HEIDENHAIN iTNC530
I am on a Hermle 800u with a Heidenhain iTNC530 controller....it had a fat fingered tool calibration program that someone deleted. Is there anyone that can give me some help with a program that calls up tools 6" from the trunion? We are using a vacuum plate and a 3" gage block for setting tool length offsets.
Thanks in advance
- HEIDENHAIN iTNC530
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules