Reply with Quotejust kidding, but one way to look at this is to be proud that it takes 60mm thickness without breaking the wire
Slow feed
I mostly cut P20 toolsteel on my Fanuc EDM. The problem I am having is that whilst trying to cut a piece 60mm thick the feed rate is painfully slow. What can I do to make it go faster?
Similar Threads:
Re: Slow feed
just kidding, but one way to look at this is to be proud that it takes 60mm thickness without breaking the wire
we are merely at the start of " Internet of Things / Industrial Revolution 4.0 " era : a mix of AI, plastics, human estrangement, powerful non-state actors ...
