just kidding, but one way to look at this is to be proud that it takes 60mm thickness without breaking the wire
I mostly cut P20 toolsteel on my Fanuc EDM. The problem I am having is that whilst trying to cut a piece 60mm thick the feed rate is painfully slow. What can I do to make it go faster?
Similar Threads:
just kidding, but one way to look at this is to be proud that it takes 60mm thickness without breaking the wire
we are merely at the start of " Internet of Things / Industrial Revolution 4.0 " era : a mix of AI, plastics, human estrangement, powerful non-state actors ...