Hi all, I'm a manual toolmaker.
I've recently been tasked to operate our agie puls, now I know very little about this machine and have only used it to spark a small hss pin.

My problem is that I need to spark a 20mm hole 16mm deep into a carbide plug. Its got a hole through the middle so flushing isn't a problem but I am struggling to get my head around what settings to have the machine on for carbide, I've reversed the polarity but its not getting far on the settings I'm using.

Can anyone give me an idea as to what needs to be where or what sort of settings I need to be looking at?

Thanks, Tom

Similar Threads: