Shop Sabre plasma


Results 1 to 2 of 2

Thread: Shop Sabre plasma

  1. #1
    Hexheadart's Avatar
    Join Date
    Mar 2021
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Shop Sabre plasma

    Help... plasma machine is stuck in a vicious cycle of 0-12 0-30 0-50 alarms . Machine is low hours but has sat for almost a year while we were using a new laser. Laser took a crap and now I gotta get plasma running for production. Water in table is new but has some rust floating in water? New filter in hypertherm 65 plasma. New electrodes and nozzles. Machine dives into aluminum and tries to keep going instead of sensing that it touched the aluminum. It constantly gets the 0-30 stuck torch combustibles alarm. Any help is appreciated.



  2. #2
    Member
    Join Date
    May 2015
    Location
    Australia
    Posts
    572
    Downloads
    0
    Uploads
    0

    Default Re: Shop Sabre plasma

    Water tables and ohmic sensing do not get along. Water enters the torch and creates a short to ground so its hard to build a circuit to sense the very minimal voltage drop. We have a solution with Linuxcnc but that may not help you. All you can do is try pulsing the torch to get post flow going before you start cutting. The Hypertherms seem to be more prone to this than my Thermal dynamics.

    Rod Webster
    www.vmn.com.au


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Shop Sabre plasma

Shop Sabre plasma

Shop Sabre plasma