Kjellberg flow control problem

[Aldoc]

Hello

I have a kjellberg hifocus plus 160i with a pgc 1 and pgv unit
We are getting a error on the pgc panel "error gas purge"

We are using Air oxygen and nitrogen gases

All three gases are exiting the torch but at the moment have no way of measuring pressure

Does anybody have knowledge of this type of machine

Any help very much appreciated

Similar Threads:

• Flow control on interface?
• CW-5200 water chiller flow alarm but flow is fine
• How to control the flow rate in a 3-phase pump?
• Question: Software, Hardware or no flow control
• Flow along a surface problem

[JasminVzd]

Hello

I have a kjellberg hifocus plus 160i with a pgc 1 and pgv unit
We are getting a error on the pgc panel "error gas purge"

We are using Air oxygen and nitrogen gases

All three gases are exiting the torch but at the moment have no way of measuring pressure

Does anybody have knowledge of this type of machine

Any help very much appreciated

Did you find the solution? I have same problem.