Problem plasma arc still on after end the pierce


Results 1 to 4 of 4

Thread: plasma arc still on after end the pierce

  1. #1

    Default plasma arc still on after end the pierce

    When my Cnc plasma cutting pierces the arc sometimes working good and sometimes no, good main the arc on and off time working at right time, but sometimes ( off ) not working right and late to end arc, machine go to the next Pierce and arc still on , l change relay in THC card with new relay but still arc on right and arc off is late, I tried to connect the arc tourch direct with the lgk power source without THC card also still the problem arc on right but arc off late, how can I fix it please

    Similar Threads:


  2. #2
    Member
    Join Date
    May 2015
    Location
    Australia
    Posts
    453
    Downloads
    0
    Uploads
    0

    Default Re: plasma arc still on after end the pierce

    You need to provide a lot more info.
    What Plasma? Machine Torch? Pilot Arc Start or HF start?
    What Controller?
    What THC.

    Rod Webster
    www.vmn.com.au


  3. #3
    Member coherent's Avatar
    Join Date
    Apr 2003
    Location
    Arizona, USA
    Posts
    531
    Downloads
    2
    Uploads
    0

    Default Re: plasma arc still on after end the pierce

    Lots more info needed. Include software to the list above. Possibly a software issue. Check your code before running it first and see if all the correct on/off code is included and your pierce delays etc are correct before you start trouble shooting hardware.



  4. #4
    Member shad71's Avatar
    Join Date
    Feb 2011
    Location
    N/A
    Posts
    36
    Downloads
    0
    Uploads
    0

    Default Re: plasma arc still on after end the pierce

    Quote Originally Posted by yamen moner View Post
    I tried to connect the arc tourch direct with the lgk power source without THC card also still the problem arc on right but arc off late
    This delay has a some LGK plasma cutters. Delay depend from the capacity of the elctrolythic capacitor in the plasma start input. Usually we find this cap and change to lower value (was for example 470 uF - change to 22 uF). Capacitor is on the main control board - just trace a start signal from connector on the cutter face panel to this PCB and find this cap (near this cap usually there are a rectification bridge - 4 diodes)

    Best Regards!
    Andrew.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

plasma arc still on after end the pierce

plasma arc still on after end the pierce

plasma arc still on after end the pierce