Build Thread Motors


Results 1 to 4 of 4

Thread: Motors

  1. #1


  2. #2
    Community Moderator Al_The_Man's Avatar
    Join Date
    Dec 2003
    Location
    Canada
    Posts
    24216
    Downloads
    0
    Uploads
    0

    Default Re: Motors

    One reason they do not sell servo motors with tachometers any more is they are no longer used on modern drives.
    These were used in the velocity mode with two loops to tune, the the tach to drive and the encoder to controller.
    At the very least, if keeping the motors, remove the tach or its brushes and refit with modern drives that can be used in torque mode etc.
    Al.

    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.


  3. #3
    Member Dem1's Avatar
    Join Date
    Sep 2019
    Posts
    54
    Downloads
    0
    Uploads
    0

    Default

    Ok, thanks
    So if I remove the tach, how would the positions of the motor's be read,
    I have not much experience with servo,
    I understood that servo needed something to transfer information back to the CNC control
    As stepper motors don't,
    I could retro fit this machine with steppers but I hear that servo is more precise, and also since I already have these servo/gearbox units it would be handy if I could still use them

    Quote Originally Posted by Al_The_Man View Post
    One reason they do not sell servo motors with tachometers any more is they are no longer used on modern drives.
    These were used in the velocity mode with two loops to tune, the the tach to drive and the encoder to controller.
    At the very least, if keeping the motors, remove the tach or its brushes and refit with modern drives that can be used in torque mode etc.
    Al.




  4. #4
    Community Moderator Al_The_Man's Avatar
    Join Date
    Dec 2003
    Location
    Canada
    Posts
    24216
    Downloads
    0
    Uploads
    0

    Default Re: Motors

    You need to fit encoders to the motors, in some cases through-hole encoders can be used by using the old Tach shaft, otherwise you would need to mount them with couplers.
    Modern servo's come with encoders attached, usually.
    Al.

    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Motors

Motors