Reply with QuoteYou can't use the parallel port with a 64 bit OS.
Yes, the ESS will work fine in Windows 10, as will the UC100.
I'd recommend the UC400ETH or UC300ETH over the UC100, though.
Ethernet smooth stepper
Hello I have a automation tek 4 axis cnc kit with the c10breakout board with mach3 connected via parallel port I get no action . I have Windows 10 64bit have installed drivers for the parallel port card but no communication to mach 3 . Hooked up to my neighbors ess with Windows 7 64 bit and we got movement just wanted to double check if Windows 10 and the warp9 ess kit will work if anybody knows ? Also I'm kinda skeptical on the uc100
Sent from my SAMSUNG-SM-G920A using Tapatalk
Similar Threads:
Re: Ethernet smooth stepper
You can't use the parallel port with a 64 bit OS.
Yes, the ESS will work fine in Windows 10, as will the UC100.
I'd recommend the UC400ETH or UC300ETH over the UC100, though.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Re: Ethernet smooth stepper
ESS board is good with window 10,
https://www.automationtechnologiesin...rd-for-mach-3/
Re: Ethernet smooth stepper
Sweet I was hoping so been dead in the water tried everythingOriginally Posted by automationtechinc
Sent from my SAMSUNG-SM-G920A using Tapatalk
