Hello, I have an old Rhino Robotics ST/6 CNC lathe that I’m trying to use. Initially, I planned on upgrading the controls and software to run Mach3 or something else. But for now, I would like to try using the original control software. Does anyone have a copy they would be willing to share/sell? I have the computer it came with, and a couple of years ago, I was able to turn it on and run the software. Now, the hard drive won’t boot, so I’m not sure where to go from there? If there is a simple way to get the hard drive to boot, I might just go that route for now. Ideally, I would get a copy of the software and start fresh with a newer used computer. Any help with this is greatly appreciated.

Similar Threads: