So I bought my self a workbee 1500x 1500 and it comes with a trial control software called Drufel CNC. Haven't put together my machine just yet, finishing my work shop. Anyway has anyone tried this program? Not much out there about it.
I know mach3 is getting old and 4 is a bit too much for me, Drufel is only 50 bucks, I just purchased this set up https://www.ebay.ca/itm/191897070448 for the bee, plus 1/2' 5 start threaded screw.
Any other recommendations for control software that don't cost an arm and a leg, going through money like a leaky boat. Workshop is a money pit, the new cnc and closed loop 34 nema kit for another larger build plus steppers for another small build so every savings I can do is a plus.
Thanks: Graham