I had stepped away from this machine for a while and just came back to mess with it and sort out the bugs. I left a machine that was operational with some hiccups and came back to a machine that wouldn't even home without a motor fault. I have been though this thing one end to the other inspecting and swapping parts and I think I have everything resolve other than one new issue that has come up. I keep blowing the 15amp output fuse from the DC power supply. The Z axis which raises and lowers the cutting bed seems to be the motor that is causing the fuse to blow and I assume its because it has the heaviest load on it. No big deal, I just need more power supply which brings up this question. I have two of these Linmot T01 420 power supplies but only enough room to mount one near the Servo drives. Would there be any issue if I mounted the power supplies on the other side of the machine which would require using roughly 8ft of wire back to the servo drives to power them? I guess the questions is any issue with using 8ft or so of wire from the power supply to the servo drives rather than having the power supplies right above the drives and only using a very short wire?