Enclosure for Gecko 540 and SmoothStepper - both in same box?

[dixdance]

Electronics newbie - I'm upgrading an old Techno Davinci router with a Gecko G540 drive and an ESS Smoothstepper. Wondering if there's any reason not to put them both in the same enclosure? I'm using the original power source in the Davinci, which is mounted in one of the gantry uprights. The gantry is fixed, the table moves, so I am planning to bolt the box to the side of the gantry

Also would like to have a 120v relay to turn on the router motor, can that also be in the same enclosure?

My concern is whether there are any noise problems with any of these components that require isolation.

All and any advice appreciated, thanks
Richard

Similar Threads:

• Need Help!- Gecko G540 + SmoothStepper with mach4
• CNC USB Kit - SmoothStepper, Gecko, PMDX, Mean Well
• SmoothStepper, Gecko Drives, PMDX BOB, Power Supplies
• Gecko g540 and SmoothStepper USB
• gecko g540 and smoothstepper

[boydage]

I asked the same question. Same box. Way to go. Just lay it out before you buy..... nothing worse than not fitting it all in lol

Sent from my SM-N970F using Tapatalk

[dixdance]

Thanks, thought as much.

What about the relay, cn that be in there also?