Why did this defect on occur ?


Results 1 to 1 of 1

Thread: Why did this defect on occur ?

  1. #1
    Member
    Join Date
    May 2008
    Location
    US
    Posts
    76
    Downloads
    0
    Uploads
    0

    Default Why did this defect on occur ?

    I'm relatively new to 3D printing. Done quite a bit over the past month or so but am still learning setting etc.

    The item in the attached photo was printed on my FlashForge Adventurer 3 printer.

    95°C bed temperature
    135°C nozzle
    ABS
    .4mm first layer
    No raft

    As you can see in the photo the bottom layer(s) moved during the 2.5 hour build. I think it was probably caused by my increase of the first layer from .28mm to .4mm but would like to hear what others think. Bed too hot perhaps for such a long construction time?

    Thanks,
    BH

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Why did this defect on occur ?-img_0729-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Why did this defect on occur ?

Why did this defect on occur ?