3 Normally Closed E-stops wired in series.
What would the circuit look like to wire two additional e-stops for a gecko g540 used in conjunction with Mach3? I have one on the controller box but need another two around the workshop. I’ve tried a few wiring variations out today but i’m flummoxed by this.
Any links or diagrams most welcome.
Similar Threads:
3 Normally Closed E-stops wired in series.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Then you wired it wrong.
If you have 3 normally closed switches in series, activating any one of them will open the circuit and trigger the input.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)