Glad you found the issue
guys i need some help. my old pc which was connected to g540 died so i replaced it to a HP workstation.
the problem is that i can't get it to work as the estop doesnt function. i ve tried some things but it seems i am hitting a wall. I am starting to believe that there is something wrong with my mobo. Is there anyway i would check the parallel to be sure it is working ok ?
guys i think i ve found it . it was a broken cable...! sorry for posting ( nto the case finally)
Similar Threads:
Last edited by Happy Feet; 06-18-2019 at 04:26 PM.
Glad you found the issue
Where is the E-Stop issue? Is this the reset button in Mach3 or the physical E-Stop across pins 10 and 12 on the G540? If it is the computer then go ahead and toggle it while measuring the pin on the DB25 with a voltmeter. You should see a voltage of 5V and 0V on that pin while it is being toggled in your software.
Does the G540 come out of FAULT mode independent of your computer?
Marcus Freimanis
www.geckodrive.com