Gweike laser cuts at bottom half of bed but not top half

[Smit1963]

I have a Gweike 1390 130w laser. The problem i am experiencing is when cutting at the bottom half of machine it cuts through material but when it is cutting in the op half of machine it does not cut through the material. This is very frustrating.

Similar Threads:

• Ideas about the half plasma half router table seen on TESTED?
• RFQ 1600 1018ste bars. Half have two holes, other half have 4 holes. I will pay S&H.
• Need Help!- Laser cuttercuts only half of the object
• Finishing a semicircular shaped (bottom half of a cylinder)
• Need Help!- Laser stops moving and burning half way