![Home](https://maxcdn.cnczone.com/images/misc/navbit-home.png)
- Problem- Need to add Rotary Axis to Vortech Router
-
Member
Need to add Rotary Axis to Vortech Router
My router has 4 stepper drivers running from a 3 axis board. My "Y" axis has two steppers, one on each side of the machine. Vortech sells a rotary for this, but they say I have to unplug the "X" axis to use it. My question is If I replaced the existing breakout board & drivers with a G540, can I run another G250 running in parrellel like I have now & still have the 4th axis to have its own port?
With that said, I do have axis to a G100. Would this be a better option?
Similar Threads:
-
-
Registered
Ever figure it out? Don't quote me on this but Im pretty sure should be able to run a 4th axis with a new breakout board. The one that shipped with my vortech had barely enough I/O to connect the minimum stuff. Matter of fact they had the Estop switch connect in series with an axis limit switch so that the machine would only run if the E stop was PRESSED. :-/ If you setup a new break out board you should be able to add a 4th axis without disconnecting anything.
-
Member
I am not sure I follow youi. Would this be wired in series with or parrell to the factory board?
-
Registered
i change my stepper motor driver CW250 and the y axis still will not work (HELP)
Also they are wires that goes to that y box that i would love some help with the y wires arrangement where to go from here ?
the computer thinks the y is working ,but have no movements on the y.
john barker
![Home](https://maxcdn.cnczone.com/images/misc/navbit-home.png)
- Problem- Need to add Rotary Axis to Vortech Router
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules