Anybody else notice that the first move would be a rapid to the UNDERSIDE of the job?Not a good idea in anybody's book.For goodness sake don't try to run any program until we have seen the first few lines of code.
Pick a system of units and stick with it and make sure the post processor that is selected from the huge range is the right one for those units.You won't be the first one to try to send a machine to a point yards outside it's physical limits because of picking the wrong one but you have been warned about it.
Importantly,set a safe height at a height equal to the workpiece plus a bit because your 1/8" could well be referenced from the part datum at the bottom.Which will lead to gouging through the piece if it actually is configured like this.
A few diagrams will help us get to the root of the problem.