Indicate feed for G01 after a G00?

[Skeeterweazel]

Hello. Once i've set the feed on a G01 (and/or G03) does it have to be set again if G01 is used after a G00?
Here is part of code. Feed set only on line 40. Machine uses fanuc commands.
N30 G00 Z1.251
N35 G00 X0.124 Y-0.183
N40 G01 Z0.2 F9
N45 G01 Z-0.655
N50 G03 X0.068 Y-0.14 I-0.05 J-0.006
N55 G01 X-0.058 Y-0.156
N60 G03 X-0.079 Y-0.167 I0.004 J-0.031
N65 G00 X0.167 Y-0.152
N70 G03 X0.111 Y-0.108 I-0.05 J-0.006
N75 G01 X-0.268 Y-0.156
N80 G03 X-0.289 Y-0.167 I0.004 J-0.031
N85 G00 X0.189 Y-0.123

Thanks.
Marty

Similar Threads:

• "Probe Lock" for G00 and G01 travel possible?
• Using G01 alongside G00 (slow feed rate woes)
• Non-modal G00,G01...G03
• feed rates and drilling and G00 question?

[Skeeterweazel]

FYI: i tried the program with just the one feed setting, and with a feed setting after each G00 and they seem to act the same.

[Algirdas]

G01 setting is global, means is active until overwritten.