Need Help! 4th axis programinng Haas VM3

Results 1 to 1 of 1

Thread: 4th axis programinng Haas VM3

  1. #1

    Lightbulb 4th axis programinng Haas VM3


    I'm stuck with this project. We have to machine a wormscrew and it was thought to be made in the haas with 4th axis. Then we face our problem, the Bobcam license own by the workshop is only able to index the 4th axis.
    I thought it could be programed directly in the control by hand, but I don't have anyexpirence, so I'm her asking for help to perform this job.

    The wormscrew data is,
    Length 750mm
    Pitch 30mm
    Blade width 1/8''

    Attached is a picture of the sketch if you want to take a look. Any advice and instruction would be appreciated.

    Stay cool and be happy.


    Similar Threads:
    Attached Thumbnails Attached Thumbnails 4th axis programinng Haas VM3-wormscrew-jpg  
    Stay cool and be happy

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts


    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on

Our Brands

4th axis programinng Haas VM3

4th axis programinng Haas VM3

4th axis programinng Haas VM3