4th axis programinng Haas VM3

[the_catalyst]

Hello,

I'm stuck with this project. We have to machine a wormscrew and it was thought to be made in the haas with 4th axis. Then we face our problem, the Bobcam license own by the workshop is only able to index the 4th axis.
I thought it could be programed directly in the control by hand, but I don't have anyexpirence, so I'm her asking for help to perform this job.


The wormscrew data is,
Length 750mm
Pitch 30mm
Blade width 1/8''

Attached is a picture of the sketch if you want to take a look. Any advice and instruction would be appreciated.

Stay cool and be happy.

Ari

Similar Threads:

• Programinng
• Haas Vf2 with 5 axis trunion B axis zero return offset
• Haas 4th axis rotary, have 4 axis simultaneous post, need help
• Are Haas VMCs Too Proprietary to Wire in a non-Haas 4th/5th Axis?
• Need Help!- Edgecam 5 axis post processors for haas umc 750 (with B+C axis)